NO NEED TO CRAWL UNDER BOAT
Connect. Flush. Done.
The E-Z LAKE® No Fuss Flush™ sends fresh water straight to your engine's raw-water inlet using the garden hose you already own. No permanent install. No complicated setup.
Featured product
Stop fighting with complicated flushing setups. Hook up your hose, open the valve, and fresh water goes right where your inboard needs it.
Pickup currently not available
Shipping only in the USA
Satisfaction guaranteed
Patent pending
Designed in the USA
How it works
Three steps. Zero fuss.
01
Connect
Attach your garden hose to the No Fuss Flush, then position it on your engine's raw-water inlet with the engine off.
02
Flush
Open the built-in valve to set your flow, start the engine, and let fresh water run through the cooling system.
03
Done
Shut the engine down, disconnect, and stow it. No permanent plumbing, nothing left behind on your boat.
Why boat owners switch
Built for boaters who would rather be on the water
- Quick setup. Uses the garden hose you already own.
- No permanent install. Nothing to plumb, drill, or modify.
- Right where it counts. Fresh water goes directly to the raw-water inlet.
- You control the flow. The built-in valve is right at your fingertips.
- Ready for any job. After a day on the water, during servicing, or warming up on the trailer.
Fresh water in. Salt, silt, and lake grime out.
A regular freshwater flush is one of the simplest ways to look after your engine's cooling system. E-Z LAKE turns it into a quick habit instead of a weekend project.
FAQ
Questions, answered
What does the No Fuss Flush connect to?
A standard garden hose on one end and your inboard engine's raw-water inlet on the other. If you have a hose and screwdriver, you have everything you need.
Do I have to install anything permanently?
No. There is no permanent plumbing and nothing to modify on your boat. Connect it when you need it, then disconnect and store it.
How do I control the water flow?
The built-in valve lets you set the flow right at the device, so you are not running back and forth to the spigot.
When should I use it?
After every outing, before and during routine servicing, or any time you need to run your inboard on the trailer.
Will it work on my boat?
The No Fuss Flush is built for inboard marine engines. Not sure about your setup? Send us your boat and engine model and we will confirm before you buy.
Any safety tips?
- Install and remove the device with the engine off.
- Make sure your water supply is on and sufficient before starting the engine.
- Keep the device and hose clear of all moving parts.
- Do not exceed your engine's normal operating temperature.
How much is shipping?
Shipping is a flat rate of $5.95 for all US locations
What if it is not right for me?
Every order is backed by our satisfaction guarantee. Reach out and we will make it right.
Still have a question? Contact us and a real person will get back to you.